Adjusting The Depth Of The Tray / Removing The Tray; Swinging The Tray Away To The Side; Using The Klickfix Adapter - Invacare Fox User Manual

6.12.2 Adjusting the depth of the tray / removing
the tray
1. Loosen the wing-screw (1).
2. Adjust the table to the desired depth (or remove it entirely).
3. Re-tighten the screw.

6.12.3 Swinging the tray away to the side

The tray can be swivelled up and away to the side to allow the user
to get in and out of the mobility device.
CAUTION!
Risk of injury! When the tray is raised it does not
lock in place in this position!
– Do not tilt the tray up and leave it leaning in this
position.
– Never attempt to drive with the tray tilted up.
– Always lower the tray in a controlled manner.

6.13 Using the KLICKfix adapter

Your mobility device can be fitted with the mini-adapter from the
Rixen + Kaul KLICKfix system. To this you can attach various
accessories such as the cellphone case supplied by Invacare, which
you can use to transport your cellphone, sports glasses etc.
1577074-A
Adjusting the mobility device to the user's seating posture
Risk posed by unsecured accessories
Accessories can fall off and get lost if they are not
properly secured.
– Check that the accessory is correctly locked in and
seated securely every time you use the mobility device.
Risk of breakage due to excessive load
The KLICKfix adapter can break if too great a load is
applied.
– The maximum permitted load on the KLICKfix
adapter is 1 kg.
Securing the accessory:
1. Push the accessory into the KLICKfix adapter.
The accessory locks in securely.
Removing the accessory:
1. Press the red button and remove the accessory.
The adapter can turn in 90° steps, allowing you to attach an accessory
from any of four different directions. Please refer to the installation
instructions which are available from your Invacare dealer or directly
from Invacare.
33