Running In And Ancillary Equipment; Aftercare - Bowers & Wilkins CT8XO MK2 Installation And Setup Manual

Running In and Ancillary Equipment

Ancillary Equipment
Speakers of this ability deserve signals of the highest quality. Choose your
electronic equipment and interconnecting cables with care. We can give
guidance on what to look for when choosing ancillary equipment, but
cannot recommend specific items. The standards of such products are
improving all the time and your dealer will be able to demonstrate a variety
of suitable up-to-date products.
In the specification we recommend a range of amplifier powers. The
higher figure is defined by the power handling capability of the speaker.
When calculating the power handling, it is assumed that the amplifier is
not run into clipping, which distorts the frequency power spectrum of the
signal, and that the signal is normal programme material. Test tones from
oscillators and the like are not applicable. The lower figure is the minimum
we consider necessary to achieve reasonable listening levels without
audible distortion in the smaller room (less than 60 m
higher the power you use, the less likely you are to experience amplifier
clipping.
You can often tell how good an amplifier is at driving complex speaker
loads by looking at its power rating into both 4Ω and 8Ω loads. The nearer
the ratio is to 2:1 the better, as it indicates a good current capability.
In order to reduce the effect the cable has on the frequency response of
the speaker to inaudible levels, the impedance of the cable at all
frequencies (measuring both positive and negative conductors in series)
should be kept as low as possible and certainly below 0.1Ω. At low
frequencies, the DC resistance of the cable is the dominant factor and you
should choose a gauge of wire sufficient to achieve the impedance
requirements over the length of cable you need to use. At mid and high
frequencies the inductive component of the impedance can dominate the
DC resistance. This and other properties influenced by the detailed
construction of the cable become important.
Running In
The performance of the speakers will change subtly during the initial
listening period. If they have been stored in a cold environment, the
damping compounds and suspension materials will take some time to
recover their correct mechanical properties. The drive unit suspensions
will also loosen up during the first hours of use. The time taken for the
speakers to achieve their intended performance will vary depending on
previous storage conditions and how they are used. As a guide, allow up
to a week for the temperature effects to stabilise and 15 hours of average
use for the mechanical parts to attain their intended design
characteristics.
However, longer run-in periods (as long as a month) have been reported
and there is evidence to suggest that this has little to do with the speaker
changing and more to do with the listener getting used to a new sound. It
is especially so with highly revealing speakers such as these, where there
may be a significant increase in the amount of detail portrayed compared
to what the listener has previously been used to; the sound may at first
appear too "up front" and perhaps a little hard. After an extended period
of time, the sound will seem to mellow, but without losing clarity and
detail.
22

Aftercare

Aftercare
The speaker cabinet surfaces and the casing of the CT8 XO usually only
require dusting. If you wish to use an aerosol cleaner, remove any speaker
grilles first by gripping round the edges and gently pulling them away from
the cabinet. Spray onto the cleaning cloth, not directly onto the cabinet.
The grille fabric may be cleaned with a normal clothes brush whilst the
grille is detached from the cabinet.
When replacing grilles, ensure that the pegs are correctly aligned with the
receptacles in the cabinet before pushing into place.
Avoid touching the drive unit diaphragms, especially the tweeter,
as damage may result.
or 2000 cu ft). The
3