Bowers & Wilkins CT8XO MK2 Installation And Setup Manual page 15

CT8 DS Only
...continue for all cases
Figure 14
Connect the signal and trigger cables to the speakers.
Using the allen key provided, remove the aluminium facing plate on the
front of the speaker, taking care that the tweeter protection cover remains
in position.
Fit the guide tubes (F) into the two through holes.
Offer the speaker into position, ensuring that the guide tubes (F) locate
over the studs of the bracket (B).
When the speaker is fully in position hard against the wall bracket,
withdraw the guide tubes.
Using a 1/4 inch socket drive with extension and the 13mm socket
provided, fit the two flanged nuts (E) onto the threaded studs and tighten.
If the socket drive does not have a nut retaining feature, we recommend
the use of a small piece of Bostik Blu-Tack or similar reusable adhesive
® ®
to prevent the nut falling out of the drive during this operation.
Replace the facing plate on the front of the speaker and remove the
tweeter protection cover.
If the speaker is mounted on the floor and recessed into a drywall having
a horizontal stud member on the floor surface, the height difference may
be taken up by fitting the optional spike feet in place of the two front roller
glides (figure 14). Only one Spike foot kit will be required for each pair of
CT8 DS.
13