Table of Contents
Advertisement
Note that if the optional feet are fitted, or if the speaker is
tilted, appropriate allowance over and above that allowed
for in the template must be made when cutting an aperture
in the wall.
The threaded bosses that hold the feet have a large conical shape on one
side of the flange. For maximum height, fit the bosses with the conical
shape towards the floor. (figure 8) For minimum height, have them pointing
into the speaker. (figure 9)
Screw in the feet close to where you think the final adjustment will be, with
the spikes or the rubber ends outermost as appropriate to the floor surface.
If you do not intend to tilt the speakers, orient the bosses with the cones
inwards and leave just enough thread exposed to fit the locking rings. Fit,
but do not tighten the locking rings.
Stand the speaker upright and adjust the feet using the metal bar provided
to give the amount of tilt required and to take up any rocking. (figure 10)
Finally, tighten the locking ring against the boss, again using the metal bar.
(figure 11)
The tweeter drive units are fitted with a protective clear plastic cover on
delivery. This is to avoid the danger of damaging the dome when installing
the speakers. Once installed, the protection cover should be removed by
simply pulling it away from the speaker.
10
Figure font: Helv 45, 7pt
Figure spacing: 7 x 7 mm
Figure font: Helv 45, 7pt
Figure spacing: 7 x 7 mm
Figure font: Helv 45, 7pt
Figure spacing: 7 x 7 mm
Figure 8
Figure font: Helv 45, 7pt
Figure spacing: 7 x 7 mm
Figure 10
Figure 8
Figure 14
Figure 10
Figure 14
Figure 8
Figure 10
Figure 9
Figure 8
Figure 11
Figure 14
Figure 10
Figure 9
Figure 11
Figure 14
Figure 9
Figure 11
Figure 9
Figure 11
Advertisement
Table of Contents
