Sony VPL-HW15 Operating Instructions Manual page 61

Symptom
Cause and Remedy
The picture is too dark.
~
Adjust the "Contrast" or "Brightness" of the Picture
III
menu
properly.
(CY'
page 44)
The picture is not clear.
~
Adjust the focus.
(CY'
page 20)
~
Condensation has accumulated on the lens. Leave the projector
for about 2 hours with the power on.
The picture flickers.
~
For pictures from a computer, activate "APA" and adjust the
current input signal.
~
Adjust "Phase" for "Adjust Signal" in the Screen
ED
menu
properly.
(CY'
page 49)
The color of characters or ~ Select the desired color registration in "Panel Alignment" of
the picture is not
Installation ~ menu
(CY'
page 55).
appropriate.
On-screen display
Symptom Cause and Remedy
On-screen display does not
~
Set "Status" in the Setup"· menu to "On."
(CY'
page 50)
appear.
~ Check if the ON/STANDBY indicator should light in green.
The model name does not
~ The display mode of the projector may be set at the time of
disappear from the screen. purchase. Consult with your local dealer or qualified Sony
personnel.
Input terminals do not
~
Set "Auto Input Search" in the Function
II
menu to "Off'.
(CY'
appear.
page 53)
Remote control
Symptom Cause and Remedy
The remote control does
~ Batteries could be weak. Replace them with new batteries.
not work.
(CY'
page 10)
~
Insert the batteries with the correct polarities.
(CY'
page 10)
~
If there is a fluorescent lamp near the remote control detector, the
projector may work improperly or inadvertently.
~
Confirm the position of the remote control detector on the
projector.
(CY'
page 7)
61