Operation Section - Toshiba RAV-SM2242DT-E Owner's Manual

Concealed Duct High Static Pressure

Operation section

Push each button to select a desired operation.
The control saves commands in memory and after the initial setting, there is no need for any additional
•
settings unless changes are desired. The air conditioner can be operated by pushing the
1
2
3
4
1
button (Temperature set button)
Adjusts the set point.
Select the desired set point by pushing
or TEMP. .
2
button (Timer set button)
Use to setup the timer.
3
button (Filter reset button)
Resets " " icon after cleaning filter.
4
button (Test button)
Use only for service.
(During normal operation, do not use this button.)
5
button
When the button is pushed, the operation starts, and it
stops by pushing the button again.
When the operation has stopped, the operation lamp and
all the displays disappear.
6
Operation lamp
Green light illuminates when unit is on.
Although it flashes when operating the protection device
or an error occurs.
7
button (Operation mode button)
Selects desired operation mode.
8
button (Fan speed button)
Fan speed is not adjustable.
It is fixed to High.
9
button (Ventilation button)
Use when a power ventilation kit (locally procured) is
connected.
• If " " is displayed on the remote controller when
this button is pushed no vent kit connected.
10
button (Power save operation)
Use to initiate power saving mode.
11
Selects a unit number (left) and louver number (right).
TEMP. UNIT:
Selects an indoor unit when multiple indoor units are
controlled with one remote controller.
LOUVER:
No Function.
12
button)
No Function.
OPTION :
Remote controller sensor
Usually the temperature sensor of the indoor unit senses the
temperature. The temperature on the surrounding of the
remote controller can also be sensed.
For details, contact the dealer from which you have
purchased the air conditioner.
– 10 –
Owner's Manual
5
6
7
8
9
10
11
12
button (Unit/Louver select button)
button (Swing/Louver direction
button.
EN
10-EN