Toshiba RAV-SM2242DT-E Owner's Manual page 13

Concealed Duct High Static Pressure
8°C OPERATION (For object pre-heating)
(Available for Super Digital Inverter outdoor units)
The air conditioner can control the heating temperature to about 8°C in the heating mode.
The 8°C heating operation requires settings with the wired remote controller. Ask the installer or dealer for the settings
according to the installation manual of the indoor unit.
Start
1 Set the displayed temperature to 18°C in the heating mode by pushing TEMP.
.
2 Set the displayed temperature to 8°C by pushing TEMP.
.
Stop
1 Set the displayed temperature to 18°C by pushing TEMP.
.
• The air conditioner returns to the normal HEAT mode. Select a desired temperature and operation mode.
NOTE
• The discharged air temperature is lower than that in the normal heating operation.
• The room temperature may not be heated evenly depending on the remote controller installation location.
• The room temperature may not reach 8°C depending on the room size or the installation conditions.
The 8°C heating operation is cancelled in the following cases.
•When operation is stopped with
•When another operation mode is selected with
•When temperature setting or operation mode is changed or operation is started/stopped by the wireless remote controller or
the central control remote controller.
• If one or more models other than the 4-way air discharge cassette type (4 series), slim duct, Concealed Duct High Static
Pressure are connected in the same control group, the 8°C heating operation is not available.
• When you use this operation mode, observe proper operating hours and we recommend that you ask service staff for
periodic maintenance of the air conditioner.
button for at least four seconds.
button.
button
button
– 12 –
Owner's Manual
button.
EN
12-EN