Specifications - Sony UP-895 Service Manual

Maintenance/Specifications
4
Close the door by pushing it.
5
Press the FEED button and keep it pressed.
When the buzzer sounds and the printer start ejecting
the cleaning sheet, release the FEED button.
Keep pressing the FEED button.
x
When the buzzer sounds and the printer
starts ejecting the cleaning sheet,
release the button.
Cleaning is completed.
6
Press the OPEN button to open the door and
remove the cleaning sheet.
7
Close the door by pushing it.
Notes
• Do not press the PRINT or COPY button while the
cleaning sheet is in the printer.
• Clean the head only when necessary. If you clean the
head too often, it may cause a malfunction.
32 Others

Specifications

Power requirements and consumption
100 to 120 V AC, 50/60 Hz, 1.5 A
220 to 240 V AC, 50/60 Hz, 0.8 A
Operating temperature
5°C to 35°C (41°F to 95°F)
Operating humidity
20 % to 80 % (no condensation
allowed)
Approx. 154 × 105 × 260 mm (w/h/d)
Dimensions
× 4 × 10
(6 1 ⁄ 1 ⁄ 1 / inches)
8 4 4
Mass Approx. 3.4 kg (7 lb 8 oz), Main unit
only
Thermal head Thin-film thermal head (with built-
in drive IC) 1280-dot drive
Gradation 256
Resolution (in WIDE 1 mode)
EIA: 1210 × 490 dots
CCIR: 1210 × 582 dots
Print size (in NOR and WIDE 1 mode)
STD mode
EIA: 94 × 72 mm
CCIR: 94 × 71 mm
SIDE mode
EIA: 126 × 96 mm
CCIR: 126 × 95 mm
Printing speed (in STD and NOR mode)
About 3.9 seconds/screen (at factory
settings)
Picture memory
800 K × 8 bits for one frame
Input/output connectors
VIDEO IN (BNC)
EIA or CCIR Composite video
signals
1.0 Vp-p, 75 ohms/high-impedance
(EIA/CCIR automatically
discriminated)
VIDEO OUT (BNC)
EIA or CCIR Composite video
signals
1.0 Vp-p, 75 ohms, loop-through/EE
switchable
REMOTE (stereo minijack)
3
2
1
1 GND
2 PRINT SIGNAL (TTL)
Input of LOW pulse over 100 msec.
initiates print.
3 PRINT BUSY (TTL)
Goes HIGH during printing.
Supplied accessories
Paper roll (UPP-110HG) (1)
BNC y BNC connecting cable (1)
AC power cord (1)
Head cleaning sheet (1)
Media label (1)
The following specifications are applied only to the
UP-895MD/895CE models:
Storage and transport temperature
–20°C to 60°C (–4°F to 140°F)
Storage and transport humidity
20 % to 80 % (no condensation
allowed)
Protection against electric shock
Class I
Protection against harmful ingress of water
Ordinary
Degree of safety in the presence of flammable
anesthetics or oxygen
Not suitable for use in the presence of
flammable anesthetics or oxygen
Mode of operation
Continuous
Design and specifications are subject to change
without notice.
Specifications
33
Others