Table of Contents
Advertisement
9. IMPORTANT INFORMATION
Changing Batteries
It is recommended that you change both transmitter
batteries at the same time. When the battery is low, a red
light will blink once every two seconds when the
automatic calibration has been completed.
The selected crank length is retained when changing the
batteries.
Do not throw the old batteries away with normal waste;
batteries should be disposed of properly according to local
regulations.
Keep batteries away from children. If swallowed, contact a doctor
immediately.
Changing Transmitter Sealing Rings
Additional sealing rings for the transmitters are included
in the product package.
Remove the existing sealing rings carefully with tweezers.
Using tweezers, place the new sealing rings carefully into
the grooves.
When changing the sealing rings, use caution to avoid damaging
them or the transmitters.
Maintenance
Before every ride, check your pedals and cleats to be sure
they are free of dirt and that they are operating properly.
Check your cleats daily for excessive wear, and replace as
indicated. Worn cleats may release inadvertently and
cause you to crash. Replace only with genuine LOOK Kéo
cleats. Do not drill, paint or refinish. Keep pedals and
cleats away from any heat source. Spindle: LOOK spindles
are subjected to a rotation test of one million cycles at
100 revs / minute, with a load of 80 kg on the pedal and
off centered rotation (which creates an impact at each
rev). This test exceeds the toughest known standard EN
14781. High pressure cleaners are not recommended.
Important Information
ENGLISH
17
Advertisement
Table of Contents
