Installation - Venturer 17” LCD TELEVISION Owner's Manual

INSTALLATION

INSTALLING / REMOVING THE BASE STAND
WARNING: The LCD Display is very fragile, and must be protected at all times when removing the base stand. Be
sure that no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact
with it. Do NOT exert pressure on the front of the unit at any time because the screen could crack.
1. Disconnect all cables or cords connected to the unit.
2. Lay the unit down on a flat surface with the back side facing up. Please make sure to place a soft cushioned
material (such as a pillow or thick piece of foam) beneath the screen.
MOUNTING ON THE WALL
This unit is VESA-compliant, and is designed to
be wall-mounted with a VESA-compliant 75mm
x 75mm mounting kit designed for flat-panel TVs
(sold separately). Mount this unit according to the
instructions included in the mounting kit.
Note : Remove the base stand before mounting
the unit on the wall.
3. To install the base stand, place the base stand on the mounting slot,
push the stand till it locks.
4. To remove the base stand, keep pressing the locking
area of the base stand and pull downwards to release
the base stand.
- 6 -