Coleman Roto Spa Owner's Manual page 35

Symptom
Water Problems
Water is not clean
High water consump-
tion
Low water stream
from the jets
No water stream from
the jets
Water leakage from
below the spa
Water Pressure Problems
Jets surge on and off
Jets are weaker than
normal or do not work
at all
Air and Jets Problems
No airstream from the
jets
Light Problems
Standard spa light does
not work
Coleman Roto Mold Spa (online sales)
LTR50001136, Rev. A
Possible Causes
For all water clarity problems, see page 22.
Very high evaporation or heavy
splashing
Running in FILTER mode - slow
speed
Block wall suctions or skimmer
Dirty filter
Jets are closed
Valves closed
Pump has airlock
Jets are closed
Power switched off, system off
Pump is defective
Pump fluctuations
Check the connections and empty
the hoses
Water level is too low
Jet valves are partially or fully closed
Filter cartridge is dirty
Air is trapped in the pump
The suction fittings are blocked
Gate valve is closed
Air control not open
Jet spout opening not fixed properly
Jet spout opening missing
Light bulb has burned out
Lighting system is defective
Possible Solutions
Use the cover and refill as necessary
Select high speed jets
Clean the wall suction/skimmer. Remove
blockage
Clean filter and replace
Open jets
Open valves
Remove airlock by priming spa (page 11)
Open jets
Reset power
Contact your dealer
Low water. Check level on skimmer flap
Close or turn off empty cycle if necessary
Add water to normal level
Open jet valves
See Cleaning the Filter
Open the air bleed valve on each pump's
housing and allow air to bleed out of the
system. Be sure to tighten each air bleed
valve as soon as water starts to flow.
Remove any debris that may be blocking
the suction fittings
Open gate valves. Note: Never operate your
spa with the gate valves closed!
Open the control
Check jet spout openings
Check jets and replace as necessary
Replace light bulb
Contact your dealer
33