AMX Mio Modero R-3 Operation/Reference Manual page 21

Serial Commands (Cont.)
IRMODE #
Sets the IR transmission
frequency to either 38 or
455KHz
^JST
Set text alignment using a
numeric keypad layout for
those buttons with a defined
address range
NUMD
Sets the number of devices to
be controlled by the remote
REBOOT
Reboots the remote
Mio Modero R-3 Remote
Syntax:
IRMODE #
Variables:
• <mode> =
38 - IR only, 38KHz
455 - IR only, 455KHz
ZIG - ZigBee only
ZIG38 - ZigBee + IR 38KHz
ZIG455 - ZigBee + IR 455KHz
Example:
IRMODE 455
Sets the IR transmission frequency to 455 KHz.
IRMODE ZIG
Sets the IR to disabled and communications to only use ZigBee.
IRMODE ZIG38
Sets the IR transmission frequency to 38KHz and configures for simultaneous
transmission on ZigBee.
Syntax:
"'^JST-<variable text address range>,<new text
alignment>'"
Variable:
• variable text address range = 1; the address range corresponds to the
dynamic line number-only one line is supported on this device.
• new text alignment = Value of 1 - 9 corresponds to the following locations:
1, 4 or 7 = Left
2, 5 or 8 = Center
3, 6 or 9 = Right
Example:
SEND_COMMAND Panel,"'^JST-1,1'"
Sets the text alignment to the left side of the LCD button
Note: There is no vertical alignment.
Syntax:
NUMD <numberOfDevices>
Example:
NUMD 1
Sets the remote to control only one device.
Syntax:
REBOOT
Example:
REBOOT
Reboots the remote
Programming The Mio R-3
17