Updating Mio R-3 Firmware - AMX Mio Modero R-3 Operation/Reference Manual

Programming The Mio R-3

Updating Mio R-3 Firmware

Updating firmware in the Mio R-3 is also done through the programming jack. To update the main
firmware for the Mio R-3:
1. Connect the Mio R-3 to your computer via the programming jack (FIG. 4).
2. Put the device into Download mode, as shown on page 8.
3. Open NetLinx Studio.
4. Set the Master Communication Settings to Axcess Master and set the baud rate to 115200.
5. Go to Tools > Firmware Transfers > Send to Axcess Device... This opens the Send to Axcess
Dialog Window(FIG. 5)..
FIG. 5 Send to Axcess Dialog Window
6. Browse to the location of the firmware file.
7. Select the file within the Files frame.
You must download two .tsk files for the Mio R-3: one main firmware file, and one for
the ZigBee module.
8. Click Query for Devices.
9. The Query For Devices field will display a complete list of all devices currently connnected to
NetLinx Studio capable of accepting the firmware file selected. Select the Mio R-3.
10. Click Send.
11. After device firmware download, check one more time to verify the firmware version change.
12. Click Close.
13. Upon confirmation of a successful send, you can exit NetLinx Studio and disconnect the
programming jack.
If you are using the Mio R-3 in conjunction with other ZigBee-enabled devices, such
as the Mio R-4 and the NXA-ZGW wireless gateway, you should update the firmware
to all of the ZigBee devices at the same time.
12 Mio Modero R-3 Remote