To Clean Chimney Back Outlet; To Replace Rocker Op Sleeve; Radiation Surface; Fire Safety - Stanley Erin Installation And Operating Instructions Manual

Hob
1. Lift off hob.
2. Remove 4 brass screws.
3. Lift off fire box cover.
4. Clean out fire box chamber.
5. Replace all parts in reverse order.

TO CLEAN CHIMNEY BACK OUTLET

Remove baffle underneath the boiler cross flow
chamber by lifting it upwards and pulling it outwards
and insert cleaning brush. Replace baffle before
lighting fire.
When fitted correctly the baffle should fall forward to
close onto the bottom of the boiler. The appliance
will not function correctly with this baffle misaligned
or missing.
Boiler
Removable
Baffle
Fig.26
Cleaning Firebox Chamber
Screws
Fig.27
Grate
TO REPLACE ROCKER OPERATING SLEEVE
1. Remove the 3 fire bars.
2. Lift the grate at the left hand end and remove it.
3. Withdraw the Rocker Operating Sleeve from
under the boiler at the right hand side.
4. Replace with new sleeve and sealing washer.
5. Replace grate and make sure that the square
shank on the centre fire bar engages with the
socket in the sleeve. See Fig.28.
Fig.28
Grate

RADIATION SURFACE

Heating surface only 23.87 Sq. M (257 sq. ft.)
Heating plus Domestic Hot Water 18.58 Sq. M. (200
sq.ft.)

FIRE SAFETY

To provide reasonable fire safety, the following
should be given serious consideration.
1. Do not over fire the stove.
2. Overfiring will also damage painted or enamel
finish.
3. Install a smoke detector in the room.
4. A conveniently located class A fire extinguisher to
contend with small fires resulting from burning
embers.
5. A practical evacuation plan.
16
Rocker Operating
Sleeve