Craftsman MiterMate 137.212260 Operator's Manual page 39

LUBRICATION (FIG. QQ)
All the motor bearings in this tool are
lubricated with a sufficient amount of
high grade lubricant for the life of the
unit under normal operating conditions;
therefore, no further lubrication is
required.
Lubricate the following as necessary:
Chop pivot: Apply light machine oil to
points indicated in illustration.
Central pivot of plastic guard: Use
light household oil (sewing machine
oil ) on metal-to-metal or
metal-to-plastic guard contact areas as
required for smooth, quiet operation.
Avoid excessive oil, to which sawdust
will cling.
CHECKING AND TIGHTENING THE
TABLE LOCK LEVER
After a period of use, the lock levers
might loosen and couldn't clamp the
sliding fence units tightly.
An adjustment is needed. Please see
ADJUSTING LOCK LEVERS section
on page 24.
Fig. QQ
Central pivot of
plastic guard
Chop pivot
39 39
Lock lever