Craftsman MiterMate 137.212260 Operator's Manual page 36

Bevel/Miter Settings
Fig. OO
Settings for standard crown
molding lying flat on compound
miter saw table
Inside Corner
ID
IL
NOTE: The chart below references
a compound cut for crown molding
ONLY WHEN THE ANGLE BETWEEN
THE WALLS EQUALS EXACTLY 90°.
BEVEL
KEY
SETTING
IL 33.9°
IR 33.9°
OL 33.9°
OR 33.9°
ED
EI
Outside Corner
MITER SETTING
Inside corner-Left side
31.6° Right
Inside corner-Right side
31.6° Left
Outside corner-Left side
31.6° Left
Outside corner-Right side
31.6° Right
1. Position top of molding against fence.
2. Miter table set at RIGHT 31.6°.
3. LEFT side is finished piece.
1. Position bottom of molding against fence.
2. Miter table set at LEFT 31.6°.
3. LEFT side is finished piece.
1. Position bottom of molding against fence.
2. Miter table set at LEFT 31.6°.
3. RIGHT side is finished piece.
1. Position top of molding against fence.
2. Miter table set at RIGHT 31.6°.
3. RIGHT side is finished piece.
36 36
TYPE OF CUT