Craftsman MiterMate 137.212260 Operator's Manual page 18

STORING THE ANGLE FINDER
(FIG. D)
Mounting the Storage Clips
The storage clips are used to store the
angle finder.
1. Install the wider storage clip (1) by
threading the bolt (2) into the hole
provided upon the rear end of the
switch handle (3).
2. Install the narrower storage clip (4)
by threading the bolt into the hole
provided upon the front end of the
switch handle.
3. Place the angle finder into the two
storage clips for storage.
FIG. D
4
Storing the MiterMate™ angle finder
(Fig. D-1)
4. Loosen the knob (5) on the
MiterMate™ angle finder to fold up
the paddles (6), then tighten the
knob to lock the paddles.
5. Move and place the angle finder
onto the storage clips (1) installed
upon the switch handle for storage
as shown.
Fig. D-1
SAW BLADE WRENCH (FIG. E)
For convenient storage and prevention
of loss, there is a slot (1) in the rear
of the switch handle (2) for storing the
blade wrench (3) when not in use.
REMOVING OR INSTALLING THE
BLADE

Only use a 10-inch diameter blade.
2
To avoid injury from an accidental
1
start, make sure the switch is in
the OFF position and plug is not
connected to the power source
outlet.
3
Removing Blade (Fig. F, G, H)
1. Unplug the saw from the outlet.
2. Allow the cutting head to rise to the
3. Loosen the cover plate screw (2)
4. Rotate the cover plate (3) towards
5. Place the blade wrench over the
6
5
18 18
FIG. E
WARNING
!
upright position. Raise the lower
blade guard (1) to the up position.
(Fig. F)
with a Phillips screwdriver.
the rear of the tool to expose the
arbor bolt (4).
arbor bolt.
Fig. F
3
1
2
1
2
3
4