Craftsman MiterMate 137.212260 Operator's Manual page 23

ADJUSTING SLIDING FENCE UNITS
SQUARENESS AND ALIGNMENT
(FIG. Q, R, S)
1. Lower the cutting arm and lock in
position.
2. Using a square, lay the heel of the
square against the worktable, and
the rule against the blade. Check
to see if the angle between the
worktable and the blade is 90°.
3. If not, make the angle to be 90° by
adjusting the bevel angle adjustment
bolt (1).
Fig. Q
4. Lay the heel of the square against
the blade, and the rule against the
left sliding fence unit (2) which is
positioned at positive stop angle 0°.
Check to see if the angle between
the blade and the left sliding fence
unit is 90°.
5. If not, unlock the left sliding fence
plate (3) by using a hex key to
loosen the three bolts (4) behind
the left slinding fence and two set
screws (5) vertically placed on the
lateral side of fence plate.
6. Adjust the left sliding fence plate
(3) to be perpendicular to the blade,
and then tighten the bolts (4) and
screws (5) to lock the plate.
Fig. R
7. Using a bar (6), lay the bar against
the left sliding fence unit (2) and
the right sliding fence unit (7) which
is also positioned at angle 0°, and
check to see if the left and right
sliding fence units are aligned on a
same line.
Fig. S
1
8. If not, unlock the right sliding fence
plate (8) by using the hex key to
loosen the three bolts (4) behind
right sliding fence plate and two set
screws (5) vertically placed on the
lateral side of fence plate.
9. Adjust the right sliding fence plate (8)
into alignment with the left sliding
fence plate (3), and then tighten the
bolts (4) and screws (5) to lock the
right sliding fence plate.
23 23
2
5
4
3
6
7 8