Troubleshooting - Craftsman 316.794990 Operator's Manual

2-cycle gas backpack blower
Hide thumbs Also See for 316.794990:
Table of Contents

Advertisement

For Parts Call 606-678-9623 or 606-561-4983
For Parts Call 606-678-9623 or 606-561-4983
UNIT WON'T START OR STARTS BUT WILL NOT RUN
C A U S E
1. Incorrect starting procedures
2. Incorrect carburetor mixture adjustment setting
3. Fouled spark plug
4. Empty fuel tank
5. Primer bulb was not pressed enough
UNIT STARTS, BUT ENGINE HAS LOW POWER
C A U S E
1. Fuel filter is plugged
2. Incorrect lever position
3. Dirty spark arrestor screen
4. Dirty air filter
5. Incorrect carburetor mixture adjustment setting
service dealer
ENGINE HESITATES
C A U S E
1. Incorrect carburetor mixture adjustment setting
2. Air filter is plugged
3. Old or improperly mixed fuel
NO POWER UNDER LOAD
C A U S E
1. Incorrect carburetor mixture adjustment setting
2. Old or improperly mixed fuel
3. Air filter is plugged
4. Fouled spark plug
RUNS ERRATICALLY
C A U S E
1. Incorrectly gapped spark plug
2. Plugged spark arrestor
3. Dirty air filter
SMOKES EXCESSIVELY
C A U SE
1. Incorrect carburetor mixture adjustment setting
2. Incorrect fuel mixture
NOTE:
For repairs beyond the minor adjustments listed above, contact your nearest Sears Parts & Repair center at
(1-800-4-MY-HOME®) or other qualified service dealer for an adjustment.

TROUBLESHOOTING

www.mymowerparts.com
www.mymowerparts.com
A C T I O N
1. Follow instructions in the Starting/Stopping section
2. Have carburetor adjusted by a Sears or other
qualified service dealer
3. Clean/gap or replace plug
4. Fill fuel tank with properly mixed fuel
5. Press primer bulb fully and slowly 10 times
A C T I O N
1. Replace the fuel filter
2. Move to Position 3
3. Replace spark arrestor screen
4. Remove, clean and reinstall filter
5. Have carburetor adjusted by a Sears or other qualified
A C T I O N
1. Have carburetor adjusted by a Sears or other
qualified service dealer
2. Replace or clean the air filter
3. Drain gas tank/add fresh fuel mixture
A C T I O N
1. Have carburetor adjusted by a Sears or other
qualified service dealer
2. Drain gas tank (see Storage)/add fresh fuel mixture
3. Replace or clean the air filter
4. Replace or clean the spark plug
A C T I O N
1. Clean/gap or replace plug
2. Clean or replace spark arrestor
3. Clean or replace air filter
A C T I O N
1. Have carburetor adjusted by a Sears or other
qualified service dealer
2. Use properly mixed fuel (40:1 mixture)
16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents