Power On Your Phone; Power Off Your Phone - Alcatel tribe 3000G User Manual

3000H
Place the SIM card with the chip facing downwards/upwards and slide it
into its housing. Make sure that it is correctly inserted. To remove the
card, press it and slide it out.
Charging the battery
(1)
Connect the battery charger to your phone and mains socket respectively.
• The charging may take about 20 minutes to start if the battery is flat.
• Be careful not to force the plug into the socket.
• Make sure the battery is correctly inserted before connecting the
charger.
• The mains socket must be near to the phone and easily accessible (avoid
electric extension cables).
• When using your telephone for the first time, charge the battery fully
(approximately 3 hours). You are advised to fully charge the battery (
• To reduce power consumption and energy waste, when battery is fully
charged, disconnect your charger from the plug; reduce the backlight
time, etc.
Depending on your country.
(1)
15
The charge is complete when the animation stops.
1.2

Power on your phone

Hold down the
code if necessary and then confirm. The main screen is displayed.
If you do not know your PIN code or if you have forgotten it, contact
your network operator. Do not leave your PIN code with your
telephone. Store this information in a safe place when not in use.
If cell broadcast messages are displayed, you can browse through them or
press to return to the main screen.
While the phone is searching for a network, "Searching/Emergency"
will be displayed.
In the power on screen, you also have access to the functions of "FM
radio", "Camera"
inserted.
1.3

Power off your phone

Hold down the key from the main screen.
).
Make sure that MicroSD card is well inserted.
(1)
key until the telephone powers on, type in your PIN
, "Music" (1) , etc. even if there is no SIM card
(1)
16