Remote Control Operations - Goldstar BG8000ER Owner's Manual

Remote Control Operations

The controls look like this:
Controls
6
5
1
POWER
To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.
This button takes priority over any other buttons.
When the unit is first powered up, it defaults to settings of High Cool at 72 F
2
TEMPERATURE SETTING
This button can automatically control the temperature of the room. The temperature can be set within a range
of 60 F to 86 F by 1 F.(16 C to 30 C by 1 C)
Select the lower number for lower temperature of the room.
3
MODE
Everytime you push this button, it will toggle between COOL, FAN, and DRY.
4
ENERGY SAVER
The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and check the room air to determine if cooling is needed.
5
ON/OFF TIMER
- Stopping Operation
Each press of the button cycles through the options in this order:
1Hour 2Hours 3Hours 4Hours 5Hours 6Hours
7Hours 8Hours 9Hours 10Hours 11Hours 12Hours CANCLE
The set t emperature will be raised by 2 F after 30 minutes and again after another 30 minutes.
- Starting Operation
Each press of the button cycles through the options in this order:
1Hour 2Hours 3Hours 4Hours 5Hours 6Hours
7Hours 8Hours 9Hours 10Hours 11Hours 12Hours CANCEL
6
FAN SPEED
Pressing the Fan speed button toggles between Low and High speeds.
7
REMOCON SIGNAL RECEIVER
4 3 2 1
Operating Instructions
7
Owner's Manual 17