Installing Board With Screw - Fujitsu Siemens Computers SCENIC D Operating Manual

System expansions

Installing board with screw

Ê
Open the casing (see "Opening the casing").
1
2
Ê
Remove the screw (1).
Ê
Remove the cover plate from the slot (2).
Do not dispose of the cover plate. For cooling, protection against fire and in order to
!
comply with EMC regulations, you must refit the cover plate if you remove the board.
Ê
Make the required settings for the board.
Ê
Push the board up to its slot (3) as far as the stop.
Ê
Press the board into the slot so that it engages.
Ê
Fasten the board into place with the screw (4).
Ê
If necessary, connect the cables.
Ê
Close the casing (see "Opening the casing").
If you have installed or removed a PCI board, please check the relevant PCI slot settings
i
in the BIOS Setup. If necessary, change the settings. Further information is provided in the
PCI board documentation.
42
4
3
Installing and removing a board
A26361-K636-Z100-9-7619