Nokia E7-00 Service Manual page 30

31) Remove the protective film.
33) Tighten these two TORX + size 4 screws to the
torque of 5 Ncm in the order shown.
35) Remove the DUMMY KEYMAT with the tweezers
and close the device.
30
32) Pull out and remove the HINGE PIN to release the
BASE CHASSIS ASSEMBLY.
34) Tighten these two TORX + size 4 screws to the
torque of 12 Ncm in the order shown.
36) Move the two coaxial cables to the side, so that
they are not damaged while assembling the ENGINE
BOARD.
Confidential | Copyright © 2010 Nokia | All rights reserved
Nokia E7-00
RM-626
Service Manual Level 1&2
Version 1.0