Preparing The Remote Control - Iiyama Prolite L400W User Manual

<Remote Control>

PREPARING THE REMOTE CONTROL

To use the remote control, insert the two dry batteries.
n
Do not use any other batteries other than those specified in this manual for the
CAUTION
Remote Control. Do not insert old and new batteries together in the Remote Control.
Make sure that the terminals match the "+" and "–" indications in the battery
compartment. Burst batteries or the electrolyte from these batteries may cause
stains, fire or injury.
A Slide open the battery case lid on the reverse of the remote control as shown in the illustration.
B Take care not to mix up the "+" and "–" terminals.
C Slide closed the battery case lid.
Push here to slide the battery case lid.
n
Replace with new batteries when the Remote Control does not work close to the
NOTE
monitor. Use AA dry batteries.
n
Operate the Remote Control by pointing it toward the Remote Sensor on the monitor.
n
Other manufacturers remote control will not work with this monitor. Use the provided
Remote Control ONLY.
7 BEFORE YOU OPERATE THE MONITOR
A Input Button (INPUT)
B Auto Button (AUTO)
Adjusts Clock, Phase, H-Position and V-Position
automatically.
NOTE
nFor best results, use the Auto Set-up in conjunction with
the test pattern Test.bmp. (See page 21 for SCREEN
ADJUSTMENTS.)
nThe screen becomes dark for approximately five seconds
during the adjustment.
C Zoom + Button (
D – Button / Contrast Button (
E Exit Button (EXIT)
F Power Switch (POWER)
G Menu Button (MENU)
H + Button / Brightness Button (
I Zoom – Button (
)
)
)
)