Table of Contents
Advertisement
Attention: You may hear a "buzzing" sound being emit-
ted from inexpensive sound systems when operated with
the inverter. This is due to ineffective filters in the sound
system. Unfortunately, this problem can only be resolved
by purchasing a sound system with a higher quality
power supply.
If the Inverter Fuse Blows?
Your PI-750 power inverter is fitted with (2) 50-AMP
spade type fuses, which should not have to be replaced
under normal operating circumstances. A blown fuse is
usually caused by reverse polarity or a short circuit within
the appliance or equipment being operated.
If the fuse does blow:
1. Disconnect the appliance or equipment immediately.
2. Find the source of the problem, and repair it.
3. Install the new fuses (supplied with your power inverter.)
The fuse compartment can be found inside the back plate
of the inverter.
Attention: Do not install a fuse higher than 50-AMPs,
as this may damage the inverter. Make sure to correct the
cause of the blown fuse before using the PI-750 again.
NOTe: If necessary, two, 40-amp spade type fuses can
be installed if 50-amp fuses are not available.
- 5 -
Hide quick links:
Advertisement
Table of Contents
