Electrolux MCC4060E Service Manual page 35

COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE
CONVECTION MOTOR REMOVAL
1. Remove the one (1) nut and washer from the
convection motor shaft.
2. Remove the convection fan from the convection
motor shaft.
3. Remove the pipe from the convection motor shaft.
4. Remove the two (2) screws holding the convection
motor angle to the convection duct.
1. CARRY OUT 3D CHECKS.
2. Push the lever of positive lock
3. Pull down on the positive lock
CAUTION: WHEN YOU (SERVICE ENGINEERS)
CONNECT THE POSITIVE LOCK
CONNECTORS TO THE TERMINALS,
CONNECT THE POSITIVE LOCK
THAT THE LEVER FACES YOU(SERVICE
ENGINEERS).
1. CARRY OUT 3D CHECKS.
2. Remove the wire leads as Positive lock® connector
removal above.
3. Lift up the oven lamp from its retaining clips by
pushing the tab of the air intake duct.
4. Now, the oven lamp is free.
REMOVAL
1. CARRY OUT 3D CHECKS.
2. Remove the one (1) screw holding the green/yellow
wire to the back plate.
3. Disconnect the leads of the power supply cord from
the noise filter, referring to the Figure C-4(a).
4. Release the power supply cord from the rear cabinet.
5. Now, the power supply cord is free.
Green/
Yellow wire
Brown wire
Noise filter
Figure C-4(a). Replacement of Power Supply Cord.
SOI 12.06 FV
POSITIVE LOCK
®
connector.
®
connector.
®
®
SO
OVEN LAMP SOCKET REMOVAL
POWER SUPPLY CORD REPLACEMENT
Power supply
cord
Back plate
Blue wire
5. Remove the cooling fan from the convection motor
shaft.
6. Remove the two (2) screws holding the convection
motor to the convection motor angle.
7. Remove the one (1) ring from the convection motor
shaft.
8. Now, the convection motor is free.
®
CONNECTOR REMOVAL
Positive lock
connector
Lever
Figure C-2. Positive lock
Lock
Figure C-3. Oven lamp.
RE-INSTALL
1. Insert the moulding cord stopper of power supply cord
into the square hole of the power angle, referring to
the Figure C-4(b).
2. Install the earth wire lead of power supply cord to the
back plate with one (1) screw and tight the screw.
3. Connect the brown and blue wire leads of power
supply cord to the noise filter correctly, referring to the
Pictorial Diagram.
Square hole
Figure C-4(b). Power Supply Cord Replacement.
35/43
Terminal
Push
Pull down
®
connector.
Bulb
Socket
Power supply cord
Moulding cord stopper
Back plate
599 37 42-75