Getting Started; Battery Installation; Assembly Instructions - VTech Go!Go! Smart Wheels User Manual

Unlock the packaging locks:

ASSEMBLY INSTRUCTIONS

Connect the short track piece to the
main unit near the recognition sensor
as shown.

GETTING STARTED

BATTERY INSTALLATION

1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the main unit. Use a coin or
a screwdriver to loosen the screw.
3. Install 2 new 'AA' (AM-3/LR6)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended for
maximum performance.)
4. Replace the battery cover and tighten
the screw to secure.
128500 IM.indd 5
Rotate the packaging locks counter-clockwise.
Pull out the packaging locks and discard them.
5
2013/8/20 15:38:39