Special Instructions For System Manager; Programming The Belt Pack For Cross-Lane Operation; Reprogramming - 3M C860 Operating Instructions Manual

Special Instructions for System Manager

Programming the
Belt Pack for
Cross-Lane
Operation

Reprogramming

18
The belt packs are factory programmed for single-lane operation to enable the
operator to press either T1 or T2 to communicate with lane 1.
For cross-lane systems, the belt packs must also be programmed to enable
communication with either lane 1 or lane 2. With the cross-lane module turned
ON, the lane 1 or lane 2 operators can press T1 to talk to lane 1 customers or T2
to talk to lane 2 customers.
To program the belt pack for dual-lane cross-lane operation:
•
While pressing and holding both the T1 and T2 switches on the belt pack,
turn the unit ON. Hold all three switches for at least 5 seconds. See
Figure 17.
•
Audible tones will be heard in the headset earpiece, indicating that the belt
pack is programmed for dual-lane cross-lane operation.
If you no longer need the dual-lane cross-lane feature, reprogram the belt pack
by repeating the above procedure.
Figure 17.
Model C860
 3M 2003
January