Oven Light Assembly - GE PT920 Technical Service Manual

4. Remove the six 1/4-in. hex-head screws that
hold the cooling fan to the oven and remove the
cooling fan
To remove the cooling fan in the lower oven:
1. Remove the oven from the installation. (See
.)
Removal
2. Remove the two 1/4-in. hex-head screws that
attach the cooling fan to the rear chassis wall
and lower the cooling fan.
3. Disconnect the cooling fan wire harness; then
cut the wire tie and remove the cooling fan.
Cooling Fan Connector

Oven Light Assembly

The ovens have two light assemblies in each oven
cavity. The incandescent light assemblies are
located on the top of the oven. The oven door switch
monitors the position of the oven door and provides
this information to the EOC. The lights come on
when the door is opened. The oven lights do not
come on if the Sabbath Feature is set.
Each light assembly consists of a removable
light cover, a light bulb socket, and a 40 watt
incandescent light bulb.
To remove an oven light assembly:
1. Disconnect power to the oven.
Oven
2. Open the oven door.
3. Remove the two 1/4-in. hex-head screws that
attach the light housing to the oven liner.
4. Pull the oven light housing from the oven liner.
5. Disconnect the wires from the light housing.
– 33 –