Oven Light Assembly - GE JKS10 Technical Service Manual

Oven Light Assembly

The GE and Profi le series ovens have one light
assembly in each oven cavity. The Monogram series
oven has two light assemblies in each cavity. The
halogen light assembly is located on the top of the
oven. The oven door switch monitors the position of
the oven door and provides this information to the
EOC. The lights come on when the door is opened
or when the oven is in a cooking cycle. The oven
lights do not come on during self-cleaning or if the
sabbath feature is set.
Each light assembly consists of a removable light
cover, a light bulb socket, and a halogen light bulb.
To remove an oven light assembly on single or
upper ovens:
1. Gain access to the control compartment. (See
Control Compartment Access
2. Disconnect the wire harness from J9 on the EOC.
3. Open the oven door and place the control panel
on a protected top oven rack.
4. Disconnect the oven light wire harness located
near the back inside wall of the control
compartment.
5. Remove the two ¼-in. hex-head screws that
attach the light housing to the oven liner.
.)
Wire Harness J9 Connector
6. Pull the oven light housing from the oven liner.
To remove an oven light assembly on lower ovens
and JKP90:
1. On JKP90, remove the microwave trim from the
microwave. (See
2. Open the lower oven door.
3. Remove 4 Phillips-head screws and the door
lock assembly cover plate from the oven.
4. Disconnect the oven light wire harness.
5. Remove the two ¼-in. hex-head screws that
attach the light housing to the oven liner.
6. Pull the oven light housing from the oven liner.
– 46 –
.)
Oven Separation