5.
Lift the left rear corner of the tray over the wire
tie and pull the tray forward and clockwise.
6. Mark and disconnect all connectors from the
relay board and the power board.
7. Compress the tab on top of each plastic
standoff; then lift the board.
The boards are held in place
by compression tabs.
Lower Oven (Double Wall Oven)
The relay board for the lower oven in a double wall
oven is located in the area between the two ovens.
To remove the relay board (lower double wall oven):
1.
Access the lower oven control compartment.
(See
Lower Oven Control Compartment Access
2.
Remove the two 1/4-in. hex-head screws from
the relay board tray.
3.
Remove the four 1/4-in. hex-head screws (one
under the relay board) that attach the vent trim
to the front of the cabinet. Remove the trim.
4.
Pull the tray forward and mark and disconnect
all connectors from the relay board.
5.
Compress the tab on the top of each plastic
standoff; then remove the board.
– 26 –
.)