Manifold Removal And Installation - Monessen Hearth iDV380NVC Installation And Operating Instructions Manual

IDV380/IDV490 Fireplace Insert

MANiFOlD ReMOVAl AND iNStAllAtiON

The manifold is shipped attached to insert. It may be
removed to allow tight installation. Manifold may be loos-
ened and rotated for desired
pipe location.
1. Remove brick liner and
baffle.
2. Remove manifold. Place
manifold in fireplace.
3. Route flex vent through chim-
ney from above. Figure 10.
Leave an extra 3" (914 mm)
at the top.
Extra 3"
Chimney
Flex
Vent
Manifold
FP2630
Figure 11 -
Attach Flex Vent to Manifold
FP2630
attach flex vent
14
Chimney
Manifold
Bracket
Nut
FP2629
Figure 10 -
Place Manifold into Fireplace
FP2629
flex vent
4. Attach flex vent to
manifold. Figure 11.
Seal with silicone
a n d a t t a c h w i t h
screws.
Flex
Vent
5. Place mani-
fold in an upright
position. Pull on
excess vent. Figure
12. Temporarily
attach flex vent
to top of chimney.
Leave some extra
slack in flex vent.
Vent
Termination
Chimney
Excess Slack
Take out of Flex
Vent
Manifold
Bracket
Nut
Insert
FP2632
place insert
VeNtiNG iNStAllAtiON
Excess
Flex
Vent
Chimney
Slack in
Flex Vent
Manifold
FP2632
Figure 12 -
FP2631
Pull on Excess Flex Vent
pull excess vent
6. Slide insert into place.
Guide the manifold
over the insert until it
is fully in place. Figure
13
7. Remove any slack from
flex vent. Attach mani-
fold to insert. Figure
13
8. Remove any excess
slack in flex line. Attach
v e n t t e r m i n a t i o n .
Figure 13
9. Replace baffle and
brick liner.
Figure 13 -
Slide Insert into Place
FP2632
57D0016