Cleaning And Maintenance; Vent System; Glass Door; Pilot And Burner Flames - Monessen Hearth iDV380NVC Installation And Operating Instructions Manual

IDV380/IDV490 Fireplace Insert
Make sure the gas valve knob is in the "OFF" position. Wait at least five (5) minutes before
start-ing maintenance.
VeNtiNG SySteM
A qualified agency should examine the venting system annually.
CleANiNG GlASS
Clean the ceramic glass periodically. Condensation will sometimes form on the glass during a
cold startup. This is normal for all gas fireplaces and inserts. This condensation often attracts
dust and lint to the surface of the glass. The initial paint curing of the appliance can also leave
a slight film on the glass. This is a temporary problem.
You should clean the glass after the first two weeks of use. After that, you should clean the
glass no more than two or three times a season. Use a mild glass cleaner to clean the door.
Do not use abrasive cleaners. They will damage the glass surface.

PilOt AND BuRNeR FlAMeS

Visually check pilot and burner flames periodically. Refer to Figure 39 for typical burner flame.
Refer to Figure 40 for typical pilot flame.
Figure 39 -
Typical Burner Flame Appearance
30
Lg774
log flames
Allow glass to cool completely before
cleaning.
Do not clean glass when it is hot.
Damage could occur.
LG774
Thermocouple
Figure 40 -
Typical Pilot Flame

CleANiNG and MAiNteNANCe

FP1943
pilot flame
Thermopile
FP1943
57D0016