ILDV20/ILDV30 Fireplace Insert
MANiFOLD ReMOVAL AND iNStALLAtiON
The manifold is shipped attached to insert. It may be removed to allow tight installation.
1. Remove glass door assembly following instructions on Page 29, Figure 34.
. Lightly tap on flange of exhaust baffle assembly towards you until disengaged. Remove baffle, manifold
and gasket from unit. Figure 10
3. ILDV0: Attach the solid closed baffle plate. ILDV30: Attach the slotted baffle plate. Figure 11
4. Feed exhaust flex through hole on top of insert and attach to manifold with hose clamp (not provided) or
other approved methods (check local codes). Insure the gasket is in place before securing the flex to the
manifold.
5. Re-attach exhaust baffle and manifold assembly in reverse order of Step .
6. Re-attach glass door in reverse order.
NOte: Insert has an adjustable baffle and may be adjusted as needed by loosening four (4) screws. Figure
11
Baffle Plate
(For ILDV0)
Baffle
Assembly
Baffle Assembly
NOte: Make sure the correct
baffle plate is used.
16
Front View
Figure 10
Remove Manifold and Attach to Flex Vent
FP1960
manifold assembly
9/08
FP156
closed Baffle Plate
Must use on iLDV20
iLDV20
fp2156
Baffle Plate
ILDV baffle assembly
12/08
Gasket
Figure 11
Baffle Assembly and Adjustment
VeNt iNStALLAtiON
FP1960
Side View
Loosen Four (4)
Screws to Adjust
Bottom View
closed Position
iLDV30
FP1961
Baffle Plate
baffle adjustment
9/08
Flex Vent
Manifold
Baffle Assembly
Bottom View
Open Position
83D0511