Electronic And Dial Controls; Digital Controls - Jenn-Air Refrigerator User Instructions

Electronic and Dial Controls

For your convenience, the temperature controls are preset at the
factory. When you first install your refrigerator, make sure the
controls are still set to the recommended setting as shown.
Style 1
Recommended Setting "4"
Style 2
Recommended Setting "4"
To Turn Off/On:
Style 1 Press the freezer Down Arrow control until a dash (-)
appears in both the refrigerator and freezer displays. Neither
compartment will cool.
Style 2 Turn the freezer control to the word OFF. Neither
compartment will cool when the freezer is set to OFF.
Energy Saver Option (on some models)
The energy saver option turns off the heater which helps to reduce
moisture on the door hinge seal. The refrigerator uses more
energy when Energy Saver is off.
Press the control to ON to save energy when the environment
is less humid.
Press the control to OFF when the environment is warm and
more humid, or if you notice moisture on the door hinge seal.
Adjusting Controls
If you need to adjust the temperature in either the refrigerator or
freezer compartment, use the settings listed in the chart below as
a guide.
To adjust the temperature, (Style 1) press the Up Arrow or Down
Arrow control, (Style 2) turn the dial to the desired setting. Except
when starting the refrigerator, do not adjust either control more
than one setting at a time. Wait 24 hours between adjustments for
the temperature to stabilize.
CONDITION/REASON:
REFRIGERATOR too warm
FREEZER too warm/too little ice
REFRIGERATOR too cold
FREEZER too cold
ADJUSTMENT:
REFRIGERATOR Control
one setting higher
FREEZER Control one
setting higher
REFRIGERATOR Control
one setting lower
FREEZER Control one
setting lower

Digital Controls

For your convenience, your temperature controls are preset at the
factory. When you first install your refrigerator, make sure the
controls are still set to the recommended set points as shown.
Recommended Settings
IMPORTANT: When the power is on, the temperature display
shows the set point temperature of the compartment.
To Turn Your Refrigerator Off/On:
Press the freezer (+) control repeatedly until "OFF" appears in
the freezer display. Allow a few seconds for the refrigerator to
shut off. Neither compartment will cool.
Press either the refrigerator or freezer (+) or (-) touch pads to
turn on the refrigerator.
Adjusting Digital Controls
The REFRIGERATOR control adjusts the refrigerator compartment
temperature. The FREEZER control adjusts the freezer
compartment temperature.
If you need to adjust the temperature in either the refrigerator or
freezer compartment, use the settings listed in the chart as a
guide.
To Adjust Set Point Temperatures:
The first touch of either the (+) or (-) touch pad displays the current
temperature set point.
Press the (+) or (-) control until the desired temperature set
point is displayed.
NOTE: Except when first turning on the refrigerator, do not
adjust either temperature control more than one setting at a
time. Wait 24 hours between adjustments for the temperature
to stabilize.
CONDITION/REASON:
REFRIGERATOR too warm
FREEZER too warm/too little ice
REFRIGERATOR too cold
FREEZER too cold
Additional Digital Control Center Features
Max Cold
The max cold feature assists with periods of high refrigerator use,
full grocery loads, or temporarily warm room temperatures.
Press the MAX COLD touch pad to set the freezer and
refrigerator to the lowest temperature settings. Press the MAX
COLD touch pad again to return to the normal refrigerator set
point.
NOTE: The Max cold feature will automatically shut off in
approximately 12 hours.
ADJUSTMENT:
Adjust REFRIGERATOR
Control 1° lower
Adjust FREEZER
Control 1° lower
Adjust REFRIGERATOR
Control 1° higher
Adjust FREEZER
Control 1° higher
13