Positioning The Cooker - Rangemaster Elise 100 Induction User's Manual & Installation Instructions

Positioning the Cooker

Fig.7-1 and Fig.7-2 show the minimum recommended
distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
The hotplate surround should be level with, or above,
any adjacent work surface. A gap of 75 mm should be left
between each side of the cooker ABOVE the hotplate level
and any adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles), this can be reduced to 25 mm.
A minimum space of 650 mm is required between the top of
the hob and a horizontal combustible surface.
*Any cookerhood should be installed in accordance with the
hood manufacturer's instructions.
** Any splashback must be tted in accordance with the
manufacturers instructions. Allowance should be made for the
ue trim, which is tted to the cooker hob.
Surfaces of furniture and walls at the sides and rear of the
appliance should be heat, splash and steam resistant. Certain
types of vinyl or laminate kitchen furniture are particularly
prone to heat damage and discolouration. We cannot accept
responsibility for damage caused by normal use of the
cooker to any material that de-laminates or discolours at
temperatures less than 65 °C above room temperature.
We recommend a gap of 1020 mm between units to allow
for moving the cooker. Do not box the cooker in – it must
be possible to move the cooker in and out for cleaning and
servicing.
If the cooker is near a corner of the kitchen, a clearance of
130 mm is required to allow the oven doors to open (Fig.7-3).
The actual opening of the doors is slightly less, but this allows
for some protection of your hand as you open the door.
When Fitting Between Kitchen Cabinets
We recommend that you either:
A.
Fit the cooker so that any cabinet doors are at least
30 mm behind the cooker door fronts. Note that this
may require an in ll piece behind the cooker.
We recommend a gap of 1020 mm between units to
allow for moving the cooker.
B.
Leave a gap of at least 13 mm on either side of the
cooker (a 1020 mm gap between units). The cooker
should be positioned centrally.
We also recommend that you do not nal x any adjacent
cabinets until the cooker is installed. Decorative mouldings
or handles on cabinet doors and fronts may interfere with the
opening of the oven doors.
Check the appliance is electrically safe when you have nished.
INSTALLATION
410 mm min
21
75 mm 75 mm
min min
650 mm min
to hotplate
1020 1100 mm min*
620 mm min
to ue trim
**
130 mm min
Fig.7-1
910 mm min
935 mm max
Fig.7-2
Fig.7-3
Fig.7-4