Dts Out; Mpeg Out; Khz Pcm Out - Pioneer DV-444-K Operating Instructions Manual

DTS Out

This player is capable of outputting DTS digital audio for
DVDs recorded in DTS. When this player is connected
to an AV component that has a built-in DTS decoder,
select [DTS]. If your system is not equipped to decode
DTS, select [Off]. Refer to the operating instructions
supplied with your audio components if you are unsure
about compatibility with DTS.
Audio1 A2 Video1 V2
Audio DRC
Dolby Digital Out
DTS Out

96kHz PCM Out

MPEG Out

Change DTS output mode
Move
Settings: Off*
DTS
Note
If you have made digital audio connections to component(s)
not equipped to decode the DTS digital bitstream, be sure to
select [Off]. If a DTS signal is output without decoding, the
output is digital noise that could potentially cause damage to
your speakers.
96 kHz PCM Out
This player is capable of outputting digital signals with a
sampling frequency of 96 kHz. If you have made
connections to a component capable of processing this
signal rate, select [96 kHz] for the signal to be output
as is. As some components are incapable of processing
digital signal input with sampling rates of 96 kHz,
selecting [96 kHz 3 48 kHz] compresses the signal to
a standard signal with a sampling rate of 48 kHz.
Audio1 A2 Video1 V2
Audio DRC
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out
Change 96kHz output mode
Move
Settings: 96 kHz 3 48 kHz*
96 kHz
Note
On DVDs that contain copy protection, the 96 kHz signal may
only be output from the analog audio jacks.
Language General
— Off
— Dolby Digital
— Off
DTS
MPEG 3 PCM
—
Exit
SETUP
*Factory setting
Language General
— Off
Dolby Digital
—
— Off
96kHz 3 48kHz
—
96kHz
SETUP Exit
*Factory setting
MPEG Out
This player is capable of outputting the MPEG digital
bitstream. When the player is connected to an AV
component that has a built-in MPEG decoder, select
the [MPEG] setting. Otherwise, select [MPEG 3 PCM]
to convert the digital signal to the PCM signal, the
digital signal output from a CD.
Audio1 A2 Video1 V2
Audio DRC
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out
Change MPEG audio output mode
Move
Settings: MPEG
MPEG 3 PCM*
Digital Out
Expert
– DVD/Video CD/CD
Depending on your preferences and the type of
connections made, you may opt not to have the digital
audio signal output at all. When this setting is set to
[Off] there is no signal output from the digital audio
output jacks.
Make changes to the [Digital Out] setting in the Setup
screen Audio 1 menu in the [Expert] menu mode
(page 23).
Audio1 A2 Video1 V2
Audio DRC
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out
Digital Out
Move
Settings: On* (Digital bitstream is output)
Off (Digital bitstream is not output)
Language General
— Off
— Dolby Digital
— Off
MPEG
MPEG 3 PCM
Exit
SETUP
*Factory setting
Language General
— Off
— Dolby Digital
Off
—
96kHz 3 48kHz
—
MPEG 3 PCM
—
— On
Off
Exit
SETUP
*Factory setting
25
En