T731 Operating Instructions - Asko T701 Use And Care Manual

T731 OPERATING INSTRUCTIONS

WARNING! To reduce the risk of electric shock or injury to persons, read the "Important Safety
Instructions" section on page 2 before operating this appliance.
THE CONTROL PANEL
Power Button
Turns power to
the machine on
and off.
Power Indicator
Light
Glows when the
power is turned on.
Program Knob
Turn to select a program.
POWER BUTTON
The Power button turns the power to the machine on
and off. When the power is on, the power indicator light
glows red. The power must be on before you can start
the machine.
PROGRAM KNOB
Turn this knob to select a program. The programs are
described on the following page.
12:00 Position – This is where the line on the knob
aligns with the line above the knob. When the knob is in
this position, "00" displays on the LED to indicate no
program has been chosen.
START BUTTON
After you have selected a program and the desired
options, press this button to start the dryer. The red
indicator light next to the Start button will come on. The
indicator light will go off when the program ends or has
been cancelled.
STOP BUTTON
You can stop or cancel a program by pressing and
holding the Stop button until the dryer stops. When you
press Start, the program will start from the beginning.
INTERRUPTING OR CANCELLING
A PROGRAM
To interrupt a program, simply open the door. The dryer
will stop tumbling automatically. To continue the
program, close the door and press Start. The program
will continue from the point it was interrupted.
To cancel a program, press and hold the Stop button
Page 14
LED Window
Displays program number, dry time
selected, remaining program time, etc.
Programs
Iron dry
Timed dry
Air fluff
Extra dry
Dry
Normal dry
Option Buttons
Press to select a
program option.
until the Stop indicator light goes off (approximately 3
seconds). You will have to reselect a program and press
Start to restart the dryer.
LED WINDOW
The LED window displays the program number for the
Sensidry programs, as illustrated below:
P1
The corresponding program numbers are:
Extra dry = P1
Dry = P2
When you select Timed Dry, the LED displays the number
of minutes selected, plus the cool-down time, as
illustrated below:
When you select Air Fluff, the LED displays the number
of minutes selected, as illustrated above. With both
programs 5 and 6, as the program advances, the LED
displays the remaining time.
"End" on the LED indicates the program is complete.
"C" indicates the program is in the cool-down cycle.
Start Button
Press to start a
program.
Stop Button
Press to stop a
program.
Normal Dry = P3
Iron Dry = P4
20