Personalisation; Setting The Temperature; Setting The Drying Cycle; Functions - Indesit IWDC 7105 Instructions For Use Manual

Personalisation

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Table of wash cycles).
The temperature may be lowered, or even set to a cold wash
ting a temperature which is higher than the maximum value set for each wash cycle.

Setting the drying cycle

Turn the DRYING knob to select the desired drying
option. There are two options:
A - Based on time: From 40 minutes to 180.
B - Based on the desired laundry dryness level:
Iron dry : suitable for clothes which will need ironing
afterwards. the remaining dampness softens creases,
making them easier to remove.
Hanger dry : ideal for clothes which do not need to
be dried fully.
Cupboard dry : suitable for laundry which can be put
back in a cupboard without being ironed.
If your laundry load to be washed and dried is much greater than the maximum stated load (see adjacent table), perform the wash
cycle, and when the cycle is complete, divide the garments into groups and put some of them back in the drum. At this point,
follow the instructions provided for a "Drying only" cycle. Repeat this procedure for the remainder of the load.
Drying only
Use the cycle selector knob to select a drying cycle (11-12) in accordance with the type of fabric. The desired drying level or
time may also be set using the DRYING knob.

Functions

The various wash functions available with this washer-dryer will help to achieve the desired results, every time.
To activate the functions:
1. Press the button corresponding to the desired function;
2. the function is enabled when the corresponding indicator light is illuminated.
Note:
- f the selected function is not compatible with the programmed wash cycle, the corresponding indicator light will flash and
the function will not be activated.
- If the selected function is not compatible with another function which has been selected previously, the indicator light corre-
sponding to the first function selected will flash and only the second function will be activated; the indicator light correspon-
ding to the enabled option will remain lit..
Selecting this option enables you to suitably adjust drum rotation, temperature and water to a reduced load of lightly soiled
cotton and synthetic fabrics (refer to the "Table of wash cycles"). "
water and electricity. We suggest using a liquid detergent suitably measured out to the load quantity.
The function saves energy by not heating the water used to wash your laundry - an advantage both to the environ-
ment and to your energy bill. Instead, intensified wash action and water optimisation ensure great wash results in the same
average time of a standard cycle.
For the best washing results we recommend the usage of a liquid detergent.
1000-500
Press this button to reduce the spin speed
Delay timer
This timer delays the start time of the wash cycle by up to 9 hours. Press the button repeatedly until the indicator light correspond-
ing to the desired delay time switches on. The fifth time the button is pressed, the function will be disabled.
N.B. Once the START/PAUSE button has been pressed, the delay time can only be modified by decreasing it until launching
the set programme.
. The washer-dryer will automatically prevent you from selec-
Table of Drying times
(guideline values)
Fabric
Load type
type
Clothing of diffe-
Cotton rent sizes, Terry
towels
Synthe-
Sheets, Shirts, Py-
jamas, socks, etc.
tics
" enables you to wash in less time thereby saving
Max. Cupboard Henger
load (kg) dry dry
5 250 210
3 180 130
GB
Iron
dry
190
115
7