Euro-Pro Ninja 1100 Owner's Manual page 9

Fig. 3a
Fig. 3b
HOW TO ASSEMBLE
CAUTION: Make sure that the motor
base is unplugged from the power
source.
1 Place the motor base on a clean, dry,
level surface.
2 Lower the pitcher or the bowl onto the
motor base. (Fig. 1)
3 Rotate the container to the left as far as
it will go. As the container rotates, it will
lower and the safety tabs on the bottom
of the container will slide under the
safety tabs on the top of the motor base.
(Fig. 2)
4 The pitcher or bowl can be placed on the
motor base two ways; the handle can be
on the front right corner or the front left
corner. (Fig. 3a, Fig. 3b)
5 Holding the desired attachment by
the shaft, place it onto the gear shaft
inside the container. Ensure that the
attachment fits around the gear shaft
and that it is standing straight.
(Fig. 4a, Fig. 4b)
NJ602_series_30_IB_ENG_120427_2.indd 9
Shaft
Fig. 4a
HOW TO USE
1 Place the pitcher or bowl onto the motor
base and insert the desired attachment.
(See 'HOW TO ASSEMBLE'.)
2 Add the ingredients to the container.
Make sure your total of ingredients
don't go higher than the highest
measured marking line on the side of
the containers.
MAXIMUM CAPACITY
40-oz Bowl
Dry - Do not exceed 2 1/2 cups (20 oz.)
Wet - Do not exceed 5 cups (40 oz.)
72-oz Pitcher
Dry - Do not exceed 2 1/2 cups (20 oz.)
Wet - Do not exceed 9 cups (72 oz.)
Shaft
Fig. 4b
www.ninjakitchen.com 9 9
12-04-30 8:44 AM