Installation Diagram Of Indoor And Outdoor Units - Toshiba RAS-24UKX Service Manual

8-2. Installation Diagram of Indoor and Outdoor Units

For installation of the indoor unit, use the paper pattern on the back of the installation manual.
Before install the wireless
remote control
• With the remote control cover
open, load the batteries supplied
correctly, observing their
polarity.
2 Wireless remote control
Cover
3 Batteries
18 Class
Loop the connective cable
(about 100 mm in diameter
and 300 – 350 mm long).
6
2
Wireless remote
control
Vinyl tape
Apply after carrying
out a drainage test.
Extension drain hose
(Option:RB–821SW)
Electric
parts cover
24 Class
Loop the connective cable
(about 100 mm in diameter
and 300 – 350 mm long).
– 25 –
For the rear left and left
Hook
piping
1
Installation
plate
Insert the cushion between
the indoor unit and wall,
and lift indoor unit to make
work easier.
Do not allow the drain hose
to get slack.
Shield
pipe
Pan head
wood screw
Make sure to run the drain
hose sloped downward.
4
Remote control holder
The auxiliary piping can be
connected the left, rear left,
rear, right or bottom.
Saddle Right
Rear
Extension drain hose
(Option:RB–821SW)
Insulate the refrigerant
Electric
parts
pipes separately with
cover
insulation, not together.
FILE NO. SVM-01010
Wall
Cut the piping hole
sloped slightly
Rear left
Bottom
Left
6 mm thick heat resisting
polyethylene foam