Indoor Unit - Toshiba RAS-24UKX Service Manual

8-4. Indoor Unit

8-4-1. Installation place
• A place which provides the spaces around the
indoor unit as shown in the above diagram.
• A place where there is no obstacle near the air inlet
and outlet.
• A place which allows an easy installation of the
piping to the outdoor unit.
• A place which allows the front panel to be opened.
CAUTION
• Direct sunlight to the indoor unit wireless receiver
should be avoided.
• The microprocessor in the indoor unit should not
be too close to r-f noise sources.
(For details, see the owner's manual.)
<Remote control>
• A place where there are no obstacles such as a
curtain that may block the signal from the indoor
unit.
• Do not install the remote control in a place exposed
to direct sunlight or close to a heating source, such
as a stove.
• Keep the remote control at least 1 m apart from the
nearest TV set or stereo equipment. (This is
necessary to prevent image disturbances or noise
interference.)
• The location of the remote control should be
determined as shown below.
(Top view)
(Side view)
Indoor unit
Remote
Reception
control
range
* : Axial distance
Fig. 8-4-1
Reception
Remote control
range
– 28 –
8-4-2. Cutting a hole and mounting installation
plate
<Cutting a hole>
When install the refrigerant pipes from the rear.
The center of the pipe
hole is above the arrow.
Fig. 8-4-2
1. After determining the pipe hole position on the
mounting plate (100 mm A), drill the pipe hole
(Ø65 mm) at a slight downward slant to the outdoor
side.
NOTE:
• When drilling the wall that contains a metal lath, wire
lath or metal plate, be sure to use a pipe hole brim
ring sold separately.
<Mounting the installation plate>
For installation of the indoor unit, use the paper pattern
on the back of installation manual (English).
Hook
170
120
Hook
Pipe hole Thread
Indoor unit
Fig. 8-4-3
FILE NO. SVM-01010
Pipe hole
6 mm
100
65
55
Installation
Pipe hole
plate
Hook
8
Mounting screw
Weight
1