Error Messages - Asko W6342 Operating Instructions Manual

Troubleshooting

Error messages

The display indicates if an error has occurred
during the program. After taking the measures
described below, turn off the machine to leave
error message mode.
The error messages that may be shown are:
The door is not closed
If the first red field beside the Start/Stop
button is flashing, you have tried to start a
program with the door open. Close the door
and the program will start.
Over flow fault
If F1 is flashing in the display.
1. Shut off the water tap.
2. Call the service division.
Water outlet fault (Grey Hose)
If F3 is flashing in the display, there is a
problem with drainage. Check:
• that no objects are stuck in the drainage
hose outlet.
• that the drainage pump is not blocked by
foreign objects. Clean the pump (see the
"Care and cleaning" chapter).
• that there are no kinks in the drainage
hose.
20
Water inlet fault (White Hose)
If F4 is flashing on the display.
Fault with water supply. Check:
• that the tap on the water pipe is open.
• that the filter in the machine's water inlet is
not blocked.
1. Shut off the water tap.
2. Unscrew the hose.
3. Clean the filter in the inlet valve on the
machine.
4. Screw the hose back on.
5. Turn on the tap and check for leaks.
6. Run the program again to check if the fault
is fixed.
7. If this does not resolve the problem, call
the service division.
Door opening fault
If F6 is flashing on the display, call the service
division.