Installing Batteries In The Remote Control; Connections; Connecting Vhf And Uhf Antennas - Samsung FP-T5894W Owner's Instruction Manual

I
Installing Batteries in the Remote Control
1 Lift the cover at the back of the remote control upward as shown in the figure.
2 Install two AAA size batteries.
~
Make sure to match the
"+"
and "-" ends of the batteries with the diagram inside the
compartment.
~
Do not mix battery types, i.e. alkaline and manganese.
3 Close the cover as shown in the figure.
~
Remove the batteries and store them in a cool, dry place if you won't be using the
remote control for a long time. The remote control can be used up to about 23 feet
from the TV. (Assuming typical TV usage, the batteries last for about one year.)
~ If the remote control doesn't work, check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power cut or is the power cord unplugged?
5. Is there a special fluorescent light or a neon sign nearby?
f ,
'\
..
'-
\
I
Connections
I
Connecting VHF and UHF Antennas
If your antenna has a set of leads that look like this, see "Antennas with 300
n
Flat Twin
Leads" below.
If your antenna has one lead that looks like this, see "Antennas with 75
n
Round Leads".
If you have two antennas, see "Separate VHF and UHF Antennas".
Antennas with 300
n
Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has 300
n
twin flat leads, follow the directions below.
1 Place the wires from the twin leads under the screws on a
300-75
0 adapter (not supplied).
Use a screwdriver to tighten the screws.
2 Plug the adaptor into the ANT 1 IN (AIR) or ANT 2 IN (CABLE) terminal on the back of the
Wireless Home AV Center.
Antennas with 75
n
Round Leads
Plug the antenna lead into the ANT 1 IN (AIR) or ANT 2 IN (CABLE) terminal on the back of the
Wireless Home AV Center.
Separate VHF and UHF Antennas
If you have two separate antennas (one VHF and one UHF), you must combine the two
antenna signals before connecting the antennas to the Wireless Home AV Center. This
procedure requires an optional combiner-adaptor (available at most electronics shops).
1 Connect both antenna leads to the combiner.
--mnF
fAA
- '.-<C :
~-; ~\~f :.
I:
---.:.::~ :~j
2
Plug the combiner into the ANT 1 IN (AIR) or ANT 2 IN (CABLE) terminal on the back of the
Wireless Home AV Center.
~,
...
_.z\~l
cA7
0
'
-=~~j ~~:F'
I:
>~)
- - - - - ANT"IIH{Alfll