Table of Contents
Advertisement
o Finally, refit the screw covers.
Reversing the doors
IMPORTANT: Make sure you have enough room
to lean the appliance back at a 45° angle. Care
should be taken not to damage or break the
condenser coils on the rear of the fridge freezer.
THE APPLIANCE MUST BE DISCONNECTED FROM THE POWER
SUPPLY BEFORE COMMENCING THE DOOR REVERSAL PROCESS.
CERTAIN SECTIONS OF THIS PROCESS WILL REQUIRE TWO
PEOPLE TO COMPLETE IT.
WE RECOMMEND THAT THE DOORS OF THE FRIDGE FREEZER
ARE REVERSED BEFORE YOU START TO USE THE APPLIANCE.
Any parts that you remove from the appliance whilst
reversing the doors, should be retained for use later.
You will require a small sized flat screwdriver and medium
sized cross-headed screwdriver to complete the door
reversal process.
The appliance will be supplied with an additional large
plastic hinge cover for the top of the fridge door that must
be used during the door reversal process (at stage 20).
Advertisement
Table of Contents
