Kyocera ECOSYS P2135dn Operation Manual page 174

>>RAM Disk
? On
>Sleep Level Set.
ID
_
7-68
RAM Disk (Setting for entering sleep mode when using the RAM
disk)
This sets whether or not the machine enters sleep mode when using the
RAM disk.
1
After entering the administrator ID and password, press  or 
repeatedly until >>RAM Disk appears.
2
Press [OK]. A blinking question mark (?) appears.
3
Select On or Off using  or .
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
Except for Europe
Select the sleep level.
The options available in Sleep Level Set. are as follows:
• ID (Administrator ID input)
• Password (Administrator Password input)
• Sleep Level (Sleep level setting)
• Network (Setting for entering energy-saving mode when connected to
a network)
• USB Cable (Setting for entering energy-saving mode when connected
to a USB)
• RAM Disk (Setting for entering energy-saving mode when using the
RAM disk)
Note Network, USB Cable and RAM Disk are only displayed
when Sleep Level is set to Energy Saver.
1
Press  while Device Common > is displayed.
2
Press  or  repeatedly until >Sleep Level Set. > appears.
>
ID (Administrator ID input)
To use the Sleep Level settings, you must enter an administrator ID. For
information on how to set the administrator ID, refer to Administrator
(Administrator settings) on page 7-81.
1
Press  while >Sleep Level Set. > is displayed.
2
The message display shows ID and a blinking cursor (_).
3
Press  or  to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified ID. Use  and  to move the
cursor right and left. Enter an ID consisting of between 1 and 16
numbers.
4
Press [OK]. Proceed to the next step Password (Administrator
Password input).
Using the Operation Panel