Stopping During Ignit Or Startphase; Easy 40 - Operation; Cleaning And Tipping During Operation; Easy 40 - Switch Off - RIKA Memo Operating Manual

key display
EASY OFF
Pressing
IGNIT
This is shown by IGNITE in the display; this is
START
replaced by START after a brief time.
EASY xx appears in the display after the
EASY 35 start phase (xx stands for a value between
30% and 100%, depending on output)
IGNIT
START
to c hang e the power setting
press „ + " or „ -" k eay ( the setting will b e c hang ed in 5 %

Stopping during ignit or startphase

If switching off occurs again 50 sec. within switching on (
sec. -key), the pellet stove returns to inactive status.
If switching off occurs during the ignition process (IGNIT or START) (at least 2
sec. -key), IGNIT OFF or START OFF appears in the display and the burn-out
phase is initiated. The pellet support stops - the flue gas fan continues to burn
any pellet residues (approximately 10 minutes). The stove changes to EASY
OFF.
EASY 40 – operation
key display
Standard display for stove switched on in
EASY 40
simple heating mode. (40 is the output in %)
EASY 45 Pressing increases output by 5%
EASY 40 Pressing decreases output by 5%
description
starts the unit.
EASY
O FF
sing le press
EASY
50
steps
-key) (at least 2
description

Cleaning and tipping during operation

The automatic cleaning process is conducted every hour for approx. 2 minutes.
During this phase the air vents that are necessary for combustion are blown
clean.
The pellet stove enters the burnout phase every 7 hours. A tipping process is
conducted automatically. The start-up phase is automatically re-initiated after
completion of the burnout phase and operation continues
EASY 40 – switch off
key display
The burnout phase is initiated by pressing for
at least 2 seconds (until the change is visible
STOP on the display). The pellet support stops -
the flue gas fan continues to burn any pellet
EASY OFF
residues (approximately 10 minutes).
The stove changes to EASY OFF.
pressing the b utton
( until the c hang e is visib le
on the display)
description
EASY
O FF
sing le press
IGNIT
START
EASY
50
c hang e power setting b y
pressing the „ + " or „ -" k ey
( c hang e in 5 % inc rem ents)
|15
14