Rear Seats; Folding Seat Backrest Forwards - Skoda Rapid Owner's Manual

Removing and installing head restraints
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the safety button » Fig. 35
A
›
To re-insert the head restraint, push it far enough down into the seat backrest
until the locking button clicks into place.
Removing and installing rear head restraints
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button » Fig.
1
into the opening using a flat screwdriver with a width of maximum 5 mm and
2
pull out the head restraint.
›
To re-insert the head restraint, push it far enough down into the seat backrest
until the locking button clicks into place.
Best protection is achieved if the top edge of the head restraint is at the same
level as the upper part of your head.
The head restraints must be adjusted to match the size of the seat occupant. Cor-
rectly adjusted head restraints together with the seat belts offer effective protec-
tion for the occupants » page 92.
WARNING
The head restraints must be correctly adjusted in order to offer effective
■
protection for the occupants in the event of an accident.
Never drive with the head restraints removed – risk of injury!
■
If the rear seats are occupied, the rear head restraint must not be in the
■
lower position.
1) If the front seats are too far back, we recommend that you have the rear head restraints removed
before the seat backrests are folded forward. Store the removed head restraints in such a way that
they are not be damaged or soiled.
and pull out the head restraint.
35, simultaneously press the locking button

Rear seats

Folding the seat backrest forwards
Fig. 36 Unlock the seat backrest
Folding forward
›
Before folding the rear seats forwards, adapt the position of the front seats in
such a way that they are not damaged by the folded rear seats
›
Put the belt tongue into the opening
vehicle – safety position.
›
Unlock the seat backrest by pressing the securing knob
pletely forwards.
Folding backwards
Ð
›
If you removed the head restraint, you need to reinsert it with the backrest til-
ted slightly forwards.
›
Then push the seat backrest back into the upright position until the securing
knob clicks into place – check by pulling on the seat backrest
›
Make sure that the red pin
1)
» Fig. 36 on the respective side of the
A
and fold it com-
B
»
is hidden.
C
Seats and Stowage
.
.
£
47