Skoda Rapid Owner's Manual page 152

WARNING (Continued)
Do not drive faster than 80 km/h (50 mph).
■
Avoid accelerating at full throttle, sharp braking and fast cornering.
■
Check the tyre inflation pressure after driving for 10 minutes!
■
The sealant is hazardous to heath. Remove immediately if it comes into con-
■
tact with the skin.
For the sake of the environment
Used sealant or sealant whose expiry date has passed must be disposed of in ac-
cordance with environmental protection regulations.
Note
Observe the manufacturer's usage instructions for the breakdown kit.
■
A new bottle of sealant can be purchased from ŠKODA Original Accessories.
■
Immediately replace the wheel that was repaired using the breakdown kit or
■
consult a ŠKODA specialist garage about repair possibilities.
Components of the breakdown kit
Fig. 116 Components of the breakdown kit
ä
First read and observe the introductory information and safety warn-
ings on page 149.
150
Do-it-yourself
The breakdown kit contains the following parts:
Valve remover
1
Sticker with speed designation "max. 80 km/h"/"max. 50 mph"
2
Inflation hose with plug
3
Air compressor
4
Tyre inflation hose
5
Tyre inflation pressure indicator
6
Air release valve
7
ON and OFF switch
8
12 volt cable connector
9
Tyre inflator bottle with sealing agent
10
Replacement valve core
11
The valve remover has a slot at its lower end which fits into the valve core.
1
This is the only way in which you can remove and re-install the valve core from
the tyre valve. The same also applies to the replacement valve core
Ð
Preparing to use the breakdown kit
ä
First read and observe the introductory information and safety warn-
ings on page 149.
The following preparatory work must be carried out before using the breakdown
kit.
›
In the event of a puncture, park the vehicle as far away as possible from the
flow of traffic. Park on as flat and firm a surface as possible.
›
Let all of the occupants get out. While changing a tyre, the occupants of the
vehicle should not stand on the road (instead they should remain behind a crash
barrier).
›
Switch off the engine and move the gearshift lever into Neutral or move the
selector lever for the automatic gearbox into position P.
›
Firmly apply the handbrake.
›
Check that you can carry out the repairs with the breakdown kit
›
If a trailer is connected, remove it.
›
Remove the breakdown kit from the boot.
›
Stick the sticker » Fig. 116
2
er.
›
Do not remove the foreign body, e.g. screw or nail, from the tyre.
›
Unscrew the valve cap.
on page 150 on the dash panel in view of the driv-
.
11
Ð
» page 149.
£