Electrolux EWS 1050 Instruction Manual page 8

Important!
Every programme has its limited temperature in order
to preventing laundry from being spoiled,so it's normal
that some temperature can not be chosed.
7. Select the SPIN SPEED or the RINSE
HOLD option
Press the SPIN SPEED button repeatedly, in order to
select the desired spin speed or the RINSE HOLD
option. The relevant light will light up. If you select the
RINSE HOLD option, the machine will stop at the end
of the programme with the water still in the tub.
Important!
Every programme has its limited spin speed in order to
preventing laundry from being spoiled,so it's normal
that some speed can not be chosed.
8. Select the desired options
If your laundry is very dirty or has stubborn stains, it
may be advisable to select the PREWASH, ANTI-
ALLERGIC RINSE option. Press the OPTIONS button
so as to cause one or both of the lights to light up. If
your laundry is only slightly soiled, depress ECONOMY
or SUPER QUICK WASH button. The relevant light
illuminates.
9.Select the DELAY START
Before you start the programme, if you wish the
starting to be delayed, press the DELAY START button
repeatedly, or keep it pressed, to select the desired
delay. The selected delay time value (up to 23 hours)
will appear on the display for 3 seconds, then the
duration of the programme will appear again.
10. Start the programme
Press the START/PAUSE button. The relevant light will
stop flashing and only the light relevant to the phase
that is in progress will remain lit. If you have chosen a
delayed start, the washing machine will begin the count-
down The display will show the duration of the
programme or the selected delay.
11. How to change a programme dur-
ing its cycle
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button. It is possible to change any phase before the
programme carries it out.
Changing the type of fabric or temperature is possible,
obviously, only during the washing phase.
If it is necessary to drain the water in order to change
the programme in progress,proceed as follows:
PAUSE the machine by pressing the START/PAUSE
button;
Press the SKIP RESET button repeatedly, until only
the DRAIN light remains lit;
Press the START/PAUSE button again.
When the water has been drained, the display shows a
blinking zero. You may now select a new programme
and press the START/PAUSE button to start it.
16
1
2
3
4
5
6
7